BOOM ITS HERE!!!!
- Thread starter jmason702
- Start date
I know autel is aware of the drone not working with a base station, it did at one-time work and then the update wiped out that option. I do know a beta tester and he told me autel is going to be updating the firmware and soon. But if you could call autel and tell them your issue to put a lil fuel on the fire to hurry up. My ideal set up is base station connected to NTRIP, base sending corrections to rover, rover being EVO 2 RTK
There's nothing to run on that screen. It just displays the status of all the connections.
My ideal setup is for my base to capture raw data and the river to capture it's own raw data and to perform PPK after the fact.
RTK is great but I've had it happen that it loses signal. And if that happens and you don't know it, ALL your data after the disconnect is ruined.
PPK allows you to verify that everything is working correctly and you don't have to work about losing connection.
Yes, you are very correct. And it will be possible soon. I know a team of guys working with autel on this very situation. All is good because the correct hardware is in place to do this. Just need everything updated to US standards
have you talked to Autel, I just got home and talked to my guy, and he said the RTK firmware was updated to allow the use of base station
I talked to autel today. The rep either didn't want to say anything or didn't know anything. He said I was the first caller he's had reporting issues about the rtk version. He said it "should" be fixed the next firmware update, but I don't think he truly understood what problems I was having. He also said he had didn't know when the next firmware update would be released.
OK.... my findings... using the SC I tried over and over and would not connect to NTRIP even though it said it was, could not fly, and had no single or fix.
So I linked up the regular controller and using an Ipad, it linked up first try, with a FIX and take off!
Are you using the smart controller?
So I linked up the regular controller and using an Ipad, it linked up first try, with a FIX and take off!
Are you using the smart controller?
I am not.
Connected to Autel Explorer app via android phone and the regular controller. I am actively looking for the SC tho.
Could you show me screenshots of yours? Does it show on the app that you have a fix? Where?
I did not take any screen shots but I will next time I fly, Yes says fix on the front screen and how many satellites are connected. Then in the RTK section, it breaks down everything and how many satellites and connected via GPS GLONASS GALOLAO, etc...
make sure your on the lastest firmware, check autels site, and do you have a I pad to try out?
ok, here are the screenshots of the RTK FIX and data link. Along with a drone deploy RMSE total error in map, just using the drones RTK. Imagine throwing in a GCP or two
Attachments
also when I was flying a small test map I seen up to 38 satellites, Tomorrow morning I will be testing sending corrections from my GNSS receiver to the drone!
Are you able to select your own mount point in the explorer app? I just tried caster but would not let me type in emlids mount mont
