- Joined
- Jan 13, 2021
- Messages
- 33
- Reaction score
- 19
Looking to see if anyone else has had this experience while using a SC. Mine is V1, but might happen on a V2 also. After doing an over air firmware upgrade to the latest version, I started to notice that the video as displayed on the monitor would "buffer" the feed for a few milliseconds. Later, when viewing the stored video on the SD card, all was perfectly normal. Kinda rules out the aircraft as the cause of the problem. Yesterday I screen recorded this happening, and here is a link to the video SC screen buffer
So, I downloaded the apk file for the Autel Explorer app onto a USB drive and then reinstalled it onto the SC. Went out a few minutes ago, and voila, no buffering in the screen video.
But I did notice that the Channel mode had defaulted to 2.4, so prior to flight, i reset to Auto mode. Went back and watched the capture video from yesterday, and after the last over air update, the channel reset to 2.4. I always leave it in Auto channel mode.
And, I have noticed that the right antennae needs to be snugged up once unfolding and bringing to the upright position when using a CCW rotation to get into place. I check both to make sure they are snug, could I have not tightened it enough? Once possibly, but every time flying since the update, unlikely.
So, any thoughts or experiences with this presently or in the past? I lean toward a bad OTA update last go around with the SC, but the Channel mode might be an issue?
So, I downloaded the apk file for the Autel Explorer app onto a USB drive and then reinstalled it onto the SC. Went out a few minutes ago, and voila, no buffering in the screen video.
But I did notice that the Channel mode had defaulted to 2.4, so prior to flight, i reset to Auto mode. Went back and watched the capture video from yesterday, and after the last over air update, the channel reset to 2.4. I always leave it in Auto channel mode.
And, I have noticed that the right antennae needs to be snugged up once unfolding and bringing to the upright position when using a CCW rotation to get into place. I check both to make sure they are snug, could I have not tightened it enough? Once possibly, but every time flying since the update, unlikely.
So, any thoughts or experiences with this presently or in the past? I lean toward a bad OTA update last go around with the SC, but the Channel mode might be an issue?