I googled what you recommended and nothing offeredTry wiggling it back in, carefully though.
if that doesn’t work, go on line google Evo 2 controller mod. View a video and follow the steps of disassembling the controller, very simple to do but watch a video first.
Good luck
Try here, its for an Evo 1 controller but same assembly. Hope the link works- good luck.I googled what you recommended and nothing offered
Thanks Pepper! I’d like to install that antenna but I installed a Lifthor bracket for my iPad. I’ll be sending back to Autel to repair.Try here, its for an Evo 1 controller but same assembly. Hope the link works- good luck.
I too have the LifThor which I like a lot! If you continue using the original antennas (which I don't recommend) fold them vertical & slightly behind the LifThor.Problem is, I installed a Lifthor bracket for my iPad. Is there a work around?
I understand, can be a hassle and do what is easiest/safest for you.Thanks Pepper! I’d like to install that antenna but I installed a Lifthor bracket for my iPad. I’ll be sending back to Autel to repair.
Same thing on my evo 1 I put a couple of drops of super attack for plastic and I solved it very wellView attachment 11327
How do I fix this? After connecting the Lifthor bracket for my iPad, the antenna did not collapse. I snapped the right side off. Work still connected though.
View attachment 11327
How do I fix this? After connecting the Lifthor bracket for my iPad, the antenna did not collapse. I snapped the right side off. Work still connected though.
Thanks!Same thing on my evo 1 I put a couple of drops of super attack for plastic and I solved it very well
Something along this line. there are many options available. I have tried different antennas with varied results.So did you replace the original ? If so, with what!
They have a little lip that snaps into the hole on the inside of controller. When I did my 4hawks I took a pair of needle nose pliers and pinched the end on the inside and rotated as I pulled from the outside and they popped right out.I understand, can be a hassle and do what is easiest/safest for you.
I don’t remember how to remove those stock antennas, if memory serves me right after splitting the case think I had to slightly twist them while pulling. This will probably be the same mounting them back in only reverse twist slight pressure forward?
Good luck!