Controller Calibration

[Goldenjet50]

When I go through the controller calibration, it does not show completed as in the guide, nor does it beep when you hold it at the end-point of each control stick setting. Just wondering if I actually calibrated it or not. It does NOT indicate that calibration is required .... nor did it ever.

 

[brian bwin]

Was there an issue with the controller you were trying to fix? The online Autel calibration guide does not mention a beeping sound so maybe you are referencing an out of date guide?

Good luck! Let us know if you got it figured out and what was the solution

 

[Goldenjet50]

It subsequently did prompt to calibrate the controller, and when I did so, it did show the graphic as in the guide and does beep at the end of each of the four ends of the left/right control stick movement and at the two ends of the gimbal pitch dial. The manual does describe the beep. So I'm good .... thanks for your response.

From written/On-line manual:
"Push both command sticks to the ends of their 4 directions, and turn the Gimbal Pitch Dial clockwise and counterclockwise to its 2 ends, holding respectively until you hear a beep. All the bars on the screen will be fully highlighted when your calibration is completed."