No Image to SE Controller

[Zoran 🇦🇺]

After flying into invisible power lines (pilot error and stupid), image was still there after the EVO II pro flipped and continued flying and I landed instantly. After removing the gimbal to check for any damage, only found 1 vibration damper damaged (finally found some and waiting for delivery) and after refitting the gimbal, I now don't have camera image on the screen but full gimbal operation still works. I have tried re pairing the controller and reset all camera settings within the explorer app. Any ideas fellow Autel pilots?

 

[MNT DRONE SOLUTIONS]

Happened to me after changing camera systems. Just re load the firmware using a micro SD card. Keep reinstall the firmware until the camera works again. I had to do mine two or three times for it to take. Quite odd but it did work

 

[Zoran 🇦🇺]

Happened to me after changing camera systems. Just re load the firmware using a micro SD card. Keep reinstall the firmware until the camera works again. I had to do mine two or three times for it to take. Quite odd but it did work

Thanks for your response. I will try this.