Has anyone else seen this issue after updating the firmware? I went ahead and updated my EVO Nano to the latest firmware on 3/29/2022 and saw an issues with the update process saying it failed. After power cycling everything it warned that the IMU needed calibration, which I did w/o issues. I also checked that the firmware numbers all checked the new ones, which they now were. HOWEVER after installing this update it appears to have broken my gimbal!! Everything was working normally just before the update but afterwards the Nano it now fails the automatic gimbal check. The gimbal just points downward and gets HOT to the touch. It also fails the calibration process when I run it. I've contacted [email protected] but have yet to hear back.
Last edited: