Failed to Start the Mission

[reynolds8126]

I imagine that he refers to connecting to the Wi-Fi network that the trimble emits with the smartcontroller to receive the corrections in the app.

@cegio exactly.

 

[elphtrooper]

So technically it's not the Al Gore internet but it still network transport, local casting.

 

[cegio]

@cegio exactly.

Well, we have a trimble to test, do we have to do something specific?

 

[reynolds8126]

We use both a Trimble SPS855 base station and a R750 base station. Each base is from the construction side of Trimble. I cannot guarantee the Survey side of Trimble is identical; however, I suspect the UI is very similar.

The 855 receiver does not broadcast a WiFi network. Therefore, we have to connect the 855 to another device via ethernet and multi-port adapter that will broadcast a WiFi network.

The new R750 base stations do broadcast a WiFi network. This feature simplifies the setup procedure as no additional third-party device is required.

Attached is a SOP document we prepared for our department to follow when using the SPS855 base station.. Some of the items may not be applicable as our third-party solution will likely differ from yours. However, the document should still provide clear instruction on how to interface with the Trimble UI.

Note, the portion of the document referring to the data logging is only required if PPK processing is to be performed. We perform RTK surveys; however, we log the data as insurance if we lose RTK lock during the survey and need to post-process the survey data.

 

[cegio]

Usamos una estación base Trimble SPS855 y una estación base R750. Cada base es del lado de la construcción de Trimble. No puedo garantizar que el lado topográfico de Trimble sea idéntico; sin embargo, sospecho que la interfaz de usuario es muy similar.

El receptor 855 no transmite una red WiFi. Por lo tanto, tenemos que conectar el 855 a otro dispositivo a través de ethernet y un adaptador multipuerto que transmitirá una red WiFi.

Las nuevas estaciones base R750 transmiten una red WiFi. Esta característica simplifica el procedimiento de configuración ya que no se requiere ningún dispositivo de terceros adicional.

Se adjunta un documento SOP que preparamos para que nuestro departamento lo siga al usar la estación base SPS855. Es posible que algunos de los elementos no se apliquen, ya que es probable que nuestra solución de terceros difiera de la suya. Sin embargo, el documento aún debe proporcionar instrucciones claras sobre cómo interactuar con la interfaz de usuario de Trimble.

Tenga en cuenta que la parte del documento que se refiere al registro de datos solo se requiere si se va a realizar el procesamiento PPK. Realizamos levantamientos RTK; sin embargo, registramos los datos como seguro si perdemos el bloqueo RTK durante el levantamiento y necesitamos procesar posteriormente los datos del levantamiento.

thanks!!!!

 

[elphtrooper]

Thank you for your answer, regarding point 7, to cast with the emlid, you still need a data connection on your mobile phone to share them with the antenna, in caster mode, the emlid receives the corrections from a server that it accesses using your data connection, and in the smart controller you put the data to connect to the connection created by the emlid. What I mean is to create this connection without the need for the emlid to connect to any server, this function can be used with the phantom 4 pro RTK, but not with the evo 2 RTK.
about point 12, we are using the UGCS mission planner because it allows you to create missions in environments with different heights, respecting the fixed height to the ground

Just to update that Emlid has a local NTRIP casting solution through Reachview 3. We are thinking about making it the default protocol in the field. I haven't seen a single float image since so we basically just band-aided a broken situation but with duct tape.