Evo II V3 Slope Missions- not following terrain

[Fischcrazy]

I have been beta testing some slope missions before having to use it for upcoming field work and can't quite figure out how to have the drone follow the slope surface. instead, it is flying at a level altitude AGL. Has anyone had similar issues or advice on how to have the drone increase altitude with respect to the angle of slope incline?

Setting points A, B, and C: should these all be at the same relative altitude AGL when set, or should point C be at the same actual altitudes of points A and B?
Settings
Height: Agl
Mission Height: 20ft (flying 20ft higher during mission)
attribute: have tried both ground and target surface

 

[DroneRat]

I have been beta testing some slope missions before having to use it for upcoming field work and can't quite figure out how to have the drone follow the slope surface. instead, it is flying at a level altitude AGL. Has anyone had similar issues or advice on how to have the drone increase altitude with respect to the angle of slope incline?

Setting points A, B, and C: should these all be at the same relative altitude AGL when set, or should point C be at the same actual altitudes of points A and B?
Settings
Height: Agl
Mission Height: 20ft (flying 20ft higher during mission)
attribute: have tried both ground and target surface

Send this to Autel Support. Maybe they will realize the documentation on the missions is dismal to say the least.

 

[DNRUASCoordinator]

I just tested today, its flying above my slope altitudes I set using AGL. I set A-B at 200ft and offset C at 100ft AG and the mission seemed to start above 200ft AGL something like 230 feet and it did reduce elevation down to 130 ft over at C. ?? Needs more testing before I rely on it.