4Hawks How To: Autel X-star premium - Controller modification

Jagerbomb52 · Sep 4, 2017

Tufargon · Sep 4, 2017

Cool, that looks like a little less work, smaller and easier than with ltelite dbs antenna mod.

Jagerbomb52 · Sep 4, 2017

I hate small screws LOL

Tufargon · Sep 4, 2017

Tell me about it. I repair laptops and there's always a gazillion of them.

intrepidusa · Sep 4, 2017

Little fuzzy on the text, looked like it said to glue what he is calling the UFL connector? This is the same one in the Itelite video that was glued.

Cider Boy · Sep 4, 2017

Well you asked to test it .. and said you would give us feedback..!

Better get that small screwdriver set out and follow the video.. !

Regards,

Cider Boy.

Jagerbomb52 · Sep 4, 2017

intrepidusa said:
Little fuzzy on the text, looked like it said to glue what he is calling the UFL connector? This is the same one in the Itelite video that was glued.

Yup same connector gets glued back on just in case.

Jagerbomb52 · Sep 4, 2017

Buddy system is happening, one other member is going to install also so it's a joint venture LOL

intrepidusa · Sep 4, 2017

Gotta love his enthusiastic music.

Jagerbomb52 · Sep 4, 2017

A lot cleaner install by using the two existing holes. Looks a lot better that way.

Cider Boy · Sep 4, 2017

Good Wishes .. hopefully you will get the range to pop over here.. !

intrepidusa · Sep 4, 2017

Agustine said:
Yup same connector gets glued back on just in case.

Couldn't see the "." in there...we didn't have those back in the 80's and 90's LOL, going to need my 4x readers.

Jagerbomb52 · Sep 4, 2017

I tell you working with those ribbon cables be extra careful. Do not force the hold down clip as they break and those ribbon cable don't crease them. I have changed a few lenses in sport cameras and those small ribbon cables can be a pain in the BUTT.

tthai826 · Sep 4, 2017

Can I pay someone to do this for me? =)

Jagerbomb52 · Sep 4, 2017

tthai826 said:
Can I pay someone to do this for me? =)

Yup when CarolinaDronz gets them in stock they would be happy to install for you
4HAWKS

jchasa · Sep 4, 2017

Agustine said:

I wonder if we could put that hole on the side or back somewhere, instead of right on the front?

Sent from my Z956 using Tapatalk

Jagerbomb52 · Sep 4, 2017

If I had a 3D printer I would make a T-bracket so I could run two of the three wires through one hole and mount the cable ends onto the T-bracket. That way if i needed to put it all back to stock there would be no hole at all.