After the update the drone does not start its motors.

[Bolivar Rosa]

I updated the Autel EVO II V3 through the controller connected to the internet, after that the drone does not turn on its motors, I have a view of the camera and I can move it, it receives the missions but it does not turn on the motors manually and it does not turn on manually either. mission planning. On the controller, when you turn on the drone it shows "latest geo-fence file download to autel drone" and I don't know where to download that document.

 

[Steve A]

. On the controller, when you turn on the drone it shows "latest geo-fence file download to autel drone" and I don't know where to download that document.

I asked about the GEO Fence and they said it was mainly for areas that are war zones.

 

[MNT DRONE SOLUTIONS]

Do the update with a micro SD card

 

[Fernando1563]

Hi, When I turned on the drone for the first time it asked me to update the firmware to version 1.1.6. it did not give me the option to decline and continue with the factory default. I followed the instructions and it does not pass the information from the controller to the drone, it gives me a connection error. I turned off the drone and I turned it back on and still with the same error and not only that it does not turn on the camera and does not read the micro SD of the drone. I have also updated the firmware of the controller to the latest version that appears on the autel robhotics page. How do I proceed to recover the drone? I uploaded a picture of the error.