Welcome, Autel Pilots!
Join our free Autel drone community today!
Join Us


  1. N

    640T V3 8k mapping?

    Hello, Is it not possible to perform a 8k mapping mission with the 640T V3? In the explorer app the max resolution I can set for a RGB mapping mission is 4096x3072 whereas the max resolution possible for a manual flight is 8192x6144. Is it possible to get around this restriction? Thanks
  2. Z

    Mapping Speed Limits based on AGL

    Hello All - new owner of an V3 RTK 640T with the "RCPAD" and pretty happy with it until I encountered an apparent speed (safety?) limitation trying to fly a polygon mission at 65' AGL and it will not let me set it faster than 2mph (speed slider will not set above 2). This tells me it's not an OA...
  3. redleger

    Aftermarket RTK compatible with EVO 2 Pro?

    So as the title says, I'm looking for a cheap skate option to get higher accuracy so I can begin mapping accurately. I've seen some after market options for DJI doing some searching, but could find nothing for Autel. Am I spinning my wheels? I don't have the funds for a Thermal, NIR, and RTK...
  4. agrofactory

    Mapping huge area

    Hi everyone, I have been asked to map a great surface around 20 km² with required GSD of 5 cm/px. The only way I've figured out is dividing the area by four and trying to map each square of 5 km² with a different EVO II. The issue comes with the requiered GSD. I would have to fly at 220 m...
  5. Y

    Mission performance further degrades with v2.3.23

    I didn't think it could get worse, but after upgrading firmware this morning, I can't believe it. At the end of each transect line, the vehicle now slows down, stops, turns moves slowly, then BACKS UP, before turning into the next transect line. Consistently adds 40 seconds at each transect...
  6. D

    Questions for Mapping and 3d Models

    I'm looking at Autel over the DJI drones I've had for mapping and creating 3d models of large areas. Mainly because DJI geofencing has ruined many projects. Need a drone for capture to create accurate 3d models with textures for areas, houses, buildings, etc. I have some questions below about...
  7. Doug Simmons

    Trying to go pro: 6K or spring for thermal?

    Hi first post but I've followed this forum for months, recreational DJI guy itching to go Autel to try my hand at making a few dollars! Tl;dr, wondering whether to spend two grand and change or go straight to the thermal? If you're in the mood to field a bunch of other questions, I've been...
  8. HigherAttitudesLLC

    Reasonable rates for mapping services?

    Hi everyone, I'm a new EVO II Pro pilot and have a fairly easy mapping job. As I'm new to aerial photography services I was hoping you all could guide me with a bid price. I'm looking for an hourly rate unless there is a more standard way of pricing jobs. This job will consist of a weekly...
  9. M

    Geo-referenced pictures

    Recently tried to join Dronebase the freelance drone pilot program with an Evo 2 pro 6k. This drone was not listed as approved. So I emailed their support and this is the response. "We have found the Autel Evo 2 Pro is not capable of taking accurate geo-referenced meta-data which is required...
  10. Tommy Molnar

    Not sure what's going on here, but it's not right.

    Out of nowhere I cannot get my maps to load, or even establish my homepoint. Given that the craft is sitting on my desk at the moment, that usually poses no problem. And, as you can see from this screen shot, I've got Chinese writing where there formerly wasn's any, and it lists meters instead...