Welcome, Autel Pilots!
Join our free Autel drone community today!
Join Us

Recent content by AtoZ

  1. AtoZ

    Connect my EVO Max 4T using SDK V2.0

    What i did compiled, controller connected to Android studio, run. App runs on controller....I'll test a bit more later as not tested with lates FW and SDK. If you made your own app from SDK you got more steps.
  2. AtoZ

    AutelRobotics asking me to perform a factory reset

    Only thing I can say, I do not trust my MAX 4T hmm yet, Yes I flew it some and it seems to work Ok, New things added but all I can say good luck. Have stopped my more testing of the MAX as I wait for more updates etc to MAKE IT WORK. Spending about $3200 for crappy OA that suppose to work and...
  3. AtoZ

    Obstacle Avoidance

    Ye, I guess we all suckers.
  4. AtoZ

    Obstacle Avoidance

    This is about MAX, GPS denied, RF hardened, Radar, etc what it says, I'm testing, I run my M30 but what MAX is suppose todo lot more I like to use it but, hmmm scary. I expect ATTI but even then OA should work. Just saying, Pedals hmm not sure he got a MAX....
  5. AtoZ

    Obstacle Avoidance

    Got my drone back :) Most of the repair cost was to fix the camera so now I'm thinking testing more, LOL take camera off :) Been asking if possible to NMEA data from drone if hmm as is support GPS spoofing....Does it have Dead Reckoning chip ? Don't know. I still wont trust OA radar support...
  6. AtoZ

    Obstacle Avoidance

    And repair cost is USD 3,181.15.
  7. AtoZ

    Obstacle Avoidance

    All I can say is I'm testing this for power line inspections and during night time. So crashing 1,2 3 if it works, better than my lost friend's in helicopter accidents. They are sending 2000+ of them to Ukraine hmm... I sent mine back for repair and LOL, Response was we fix it in 2 weeks, over...
  8. AtoZ

    Obstacle Avoidance

    Well to elaborate a bit. I turned off in app was a bit misleading. In my app that controls the SDR that can fake/block GPS. And I did not turn off OA. I was hoping that The radar would help to provide some OA but seems it has some glitches not giving good values. I was basically in Atti mode...
  9. AtoZ

    Obstacle Avoidance

    Worked ok with disable GNSS in app yes it drifted some in the wind but what I saw the OA worked some what ok. Flew inside building. I also have a SDR I use to fake GNSS signal etc to test some hardening. This discussion again :) This is about OA.
  10. AtoZ

    Obstacle Avoidance

    I found that OA works pretty good but be aware it still got glitches especially the latest firmware. Did some flying without GNSS and was pretty happy with it but.. glitches. I crashed my drone 2 times now testing to see how good it is. I should have taking the camera off as the first crash it...
  11. AtoZ

    AutelRobotics asking me to perform a factory reset

    Thats a scary one, Lot of settings might be in RC but lot are sent to aircraft also, the firmware in RC and Aircraft etc need to be in sync. Make sure all have latest FW in all, Might be HW issues.
  12. AtoZ

    EVO Max 4T Altitude offset 120'

    hmm, Now i feel I need to compare the M30 vs 4T like 10k ft :), nah I gonna find more things.......
  13. AtoZ

    Thermography and related training/certifications

    So when you all take the UAS specific please tell me what you learned as I like to know. Thanks.
  14. AtoZ

    Thermography and related training/certifications

    But as a basic what Raptor want from a 640R https://raptormaps.com/solar-tech-docs/autel-evo-ii-dual-640r Now if you go with say GRC well I think all apply also. You can basically apply that to any thermal you doing but some training what setting does and used for is, hmm important .... As in...
  15. AtoZ

    Rear obstacle avoidance always detects an obstacle at 1.1m

    I have the same problem on my EVO 1 but I did not crash it several times (where did all the glue go) but I have to put it into ludi mode to fly normal, Sounds like a bad Sensor. (If you start covering something good it outside limit and can disable all.)