Recent content by Jack_K

Thanks for the suggestion. I haven't tried that specific course of action yet. It's extremely frustrating when I have to restart an 80 minute mission twice because the stupid drone or controller glitches when trying to resume, then I don't have enough batteries left to finish, then I wasted a...

So I've encountered a bit of a glitch when flying in RTK mode. When a battery change is required, the drone comes home, I change the battery, and power the aircraft back up. No issues. Upon the controller reconnecting to the drone, I'm immediately prompted to "RESUME MISSION - YES OR NO". If...

THanks for the tip. Agreed that Autel support is glacially slow. I get better support from the distributor I purchased the drone from. On an unrelated note I recently discovered (due to my own ignorance on the topic) that a base station is not needed and that many US states have a public RTK...

So I watched the Youtube video on the EMLID RS2 and it avertises LoRa 915 MHz connectivity. Does that mean it could use the Helium Network for connectivity rather than the sunsetted 3G cell network?

So I was flying a pre-planned mission last week for mapping a rooftop at ~150' AGL and the aircraft battery ran low, so the device returned to home. I swap the battery, power it up, bring it ~10' of elevation, and tell the aircraft to resume the mission. Upon doing to, the aircraft dives down...

Thanks for the reply. I was getting an error message when attempting an OTA update. I tried the manual method but the instructions were vague and incomplete, which led to an unsuccessful attempt. For example, the instructions at this page (How To Update EVO Firmware Manually?) and the video...

I recently got a Evo II Dual R and was flying this past weekend and ran into some annoying problems. 1. The Smart Controller cannot push a firmware update to the aircraft (2.7.35 as displayed on the Smart Remote). It fails evertime. Trying to manually put the BIN or ZIP files onto the SD...