Recent content by actruck

I know this isn't a DJI board but I'm sure some of you have both as I do. I decided I wanted the same case for my Mavic Pro. Both cases turned out nice and now I have the ability to rearrange as needed. Cost was also a factor.

This is the first time I've worked with the coroplast dividers so go easy. I was able to fit everything in the case except my tablet adapter. I looked at the Trekpak product but that stuff is too expensive. I chose the coroplast and armaflex insulation instead. I see a few things I would change...

Thank you. I have tried every combination possible on these two mounts and so far balance is very good even with the 9.7. I can see pretty much the entire RC screen on the double mount adapter too. That's a plus.

I realize some of you do not care for the tablet adapters. I respect that but there are a few of us that do so please be respectful with the comments. My goal was to have a tablet adapter where I could use a front or rear mount tablet. I wasn't happy with the rear mount on the original design...

I've been looking for a tablet holder for my EVO but all I could find was the Thor. The Thor appears to be very well made but the cost is just a little much so I decided to design one similar to the one I made for my Mavic Pro. This is still a work in progress but I hope to have it powder coated...

^^^^ What he said. ^^^^

I too ran into this issue. I decided to go a different route because I didn't want to block any of the other ports on the rear of the controller. Using this method also allows me to use a short cable to my tablet. So far it's easy to plug and unplug. The adapter I used was an "Up Angle". I also...