Recent content by TCLMike

I just emailed Autel Support to see if they have an answer. If they get back to me, I'll post the results.

I had an issue logging into a local state's CORS site initially, but after some checking I found that I had the wrong IP address on the Autel. Once I changed that, I was all set. I have noted that connection to single point sites is far less consistent than selecting a VRS mountpoint. Sorry...

I'm replying quickly (perhaps more later) as I need to get some more pressing work stuff done presently. If you recall at the start of our conversation, I had only used 3 GCPs - that's because GCP1 recorded with 0.04 horizontal and 0.07 vertical errors; GCPs 2-4 were all 0.01 horizontal and...

Quality report from the processing after applying your wisdom - let me know if I missed anything. Thank you!

I’m replying to this on my phone. When I get back to my computer I will give you a more comprehensive reply. But than you!

JaJa6009, You are a genius, wizard, or whatever you'd like to be addressed as! I did what you said and you will see from the attached post-Basic and RayCloud Editor screenshots it seems to have fixed my problem. Now, I'll need to digest it and develop a new workflow to deal with it. Thank...

JaJa6009, Thank you so much for the time you have taken to educate a mere novice in the field, although I've been at it for just about 4 years now! I had a very short Pix4D course, back in 2019, when the vendor provided us a 'quick start' course after entering the UAV/Point Cloud/Pix4D world...

See the post below.

Jaja6009 - thank you very much. I'll try to answer your questions below. Photo Coordinates: 44.28734717, -70.52334637, 141.712 meters elevation GCP Coordinates: Maine State Plane - West NAD83 GCP2,529600.012,2859941.393,447.324 GCP3,529996.365,2859543.003,452.882...

We just purchased two Autel EVO II V3 Pro RTK drones. Firmware update issues - Smart Controller not connecting to the aircraft -lots of issues, almost tossed it in the trash. Called Autel Support and left a message. Ray called back the next day and advised that it was an Android System issue...

I was hoping to learn the same - following. I have yet to figure it out.

Is there a way to correct for this? I'm using an EVO II V3 RTK and processing in Pix4D. When I import my images, they seem to be accurately displayed at about the 100' AGL that I flew at. However, when I import the GCPs the projected camera positions are at or below ground level. Using the...