Recent content by Salv

LifThor Mjolnir for EVO I & II controller for sale. Mint condition. Tablet mount holder for AUTEL EVO 1 & 2 Remote Controler. A very secure hold for your tablet or Phone. Comes with original mount, screws and additional 3D printed mount for alternative tablet / phone holder. I have also...

I Don't think mine is a Camera cable issue. On starting my drone, the flickering is not present. A positive connection ?. Turn the drone off, and on again, the flickering is not there. I can fly in photo mode and all is good. As soon as i change from photo mode to video, or video to Photo, the...

Hi Iv done many configurations, all the same. Waiting for a response from Autel. It's flying great no problems there. I can take pictures although I have to take a few to get the right exposure. Video is a no no. The problem is the camera/drone as even when I just use the controller only, I...

Hi guys I've got this flickering, Evo 1 pro. Is it the same as yours, or have I got it bad. This displays on my screen and all my videos I've also contacted Autel and they've given me a ticket number. Still waiting and I've only got 2 months left before the warranty runs out. How frustrating. On...

Hi l use ThinkTank photo Urban Disguise 35v2

Hi all. Bit late to the party ? My question is..1. dose the hub charge two batteries at the same time and for how long would it be till both are fully charged. 2. Dose the hub have a battery condition health check? 3. Or would it be faster to get a standard second autel charger and charging two...

Hi Good news for me and info for all. To my surprise I received my new replacement low noise props a few days early. Front white was the very loose floppy prop so switched it out with the new white! Test flight / hover (10feet) still the same vibrations. Landed and put on the original white...

hi When I get a chance I'll check for updates, redo the IMU calibration and compass. Check over the drone. I know it's not the drone, I have it on my lap looking at it. No cracks, splits or plastic fatigue. Checking each motor rotation for a bent bell/shaft. I don't know why I'm checking for...

Hi 808 I did the swap but to no avail. I even tried the petals OEM that came with the drone and all is good. The new Low noise props apart from the very floppy one have about the same friction on the hinges as the OEMs. As soon as I get a chance I will do a slow motion video and see. Thanks

Make the voyager controller compatible with the AP2 The controller they already have! What a lovely big screen and a all in one controller. No more faffing about with attaching a phone or tablet.... Wires! Make it with a data sim!

Hi. Iv just tested the new low noise props today only to find that there's an issue. Lower noise they have, but iv got vertical shaking. Buzzing like a bee! It comes and goes. A few gentle manoeuvres and it's ok, but in a hover it vibrates bad. Stopped and swapped them back to the OEM petal...