Remember I wrote that after my drone was updated by air to firmware 2.1.57, one motor stopped working?
autelpilots.com
So after installing firmware 2.1.61, the motor started working, but the camera suspension began to fill up the horizon. I decided to roll back to stable firmware 2.1.31, but again, when installing the firmware, the same motor ESC4 refused to flash. I flashed the drone ten times and the motor ESC4 is still not flashed. I again decided to flash for beta 2.1.61, but I got the same error in the ESC4 motor firmware. Can anyone tell me what the problem is? And how to solve it?
Yesterday I flew and there were no problems (excluding the problem with the motor with firmware 2.1.57) until today I decided to roll back the firmware.
AUTEL EVO II FIRMWARE UPDATE: Constantly updated ( new V1 STABLE fw 2.7.35) - 28/02/2022 - (NEW V2 STABLE fw 2.3.8 - 19/04/2022)
Just updated to the latest firmware and the 3 advanced settings for things like Yaw were blank, so I entered 100,100,65 (sorry, cannot remember exactly what they are, but my EXP settings are fine). Then I went back and I saw N/A flash in each box and then go blank again. I tried removing Autel...
autelpilots.com
So after installing firmware 2.1.61, the motor started working, but the camera suspension began to fill up the horizon. I decided to roll back to stable firmware 2.1.31, but again, when installing the firmware, the same motor ESC4 refused to flash. I flashed the drone ten times and the motor ESC4 is still not flashed. I again decided to flash for beta 2.1.61, but I got the same error in the ESC4 motor firmware. Can anyone tell me what the problem is? And how to solve it?
Yesterday I flew and there were no problems (excluding the problem with the motor with firmware 2.1.57) until today I decided to roll back the firmware.
Last edited:
