Recent content by fpt

Found it. Under Flight Control/Gimbal/Pitch Sensitivity

I recently installed a brand new 8k camera on my EVO II Pro. Everything works well except the gimbal pitch, controlled by the left wheel on the controller, moves so fast as to be unusuable. I had to switch to the slider bar on the display. Is there a way to adjust the speed of the gimbal pitch...

Problem solved. Thank you. I was unable to update the firmware from the SD card, it was not seeing it. So, I uninstalled the app and reinstalled it on my phone. Then on startup it showed new firmware available. I let it install and it appears all is well. Thanks again.

After firmware update 2.7.35 the gimbal on my EVO II Pro will not respond to input from the wheel. I have run the gimbal calibration process which it completes successfully but the problem persists. Any suggestions?

I've tried to research shipping into Canada and find it difficult to get a straight answer. Therefore I'm going to decline shipping to Canada. Thanks for your interest and good luck acquiring a drone.

It has not been sold. I'm looking into shipping to Canada and will let you know in a day or two.

No I have not sold it yet.

EVO II Pro on the go bundle for sale. Includes: EVO II Pro 2 batteries. One has 16 discharges, the other 17. Controller Charger and cables Spare propellers Carrying case Original boxes I used it to do aerial photography of my own property and no longer need it. This unit has no cosmetic...

EVO II Pro on the go bundle for sale. Includes: EVO II Pro 2 batteries. One has 16 discharges, the other 17. Controller Charger and cables Spare propellers Carrying case Original boxes I used it to do aerial photography of my own property and no longer need it. This unit has no cosmetic...

Thanks for your interest. Actually I have realized that in the first instance the drone did not return to home because of overhead branches. EVO II's obstacle avoidance is amazing. I had basically flown down a wooded trail. So it had no choice other than to hover. In the second instance it rose...

Correct. But when the drone goes into go home mode and rises into line of sight the connection should be reestablished. That is the issue I'm talking about.

On my last two flights, less than 1,000 feet out but behind some trees, EVO II disconnected from the controller. Not the first time I've done that. It should go into go home mode and elevate to where I can reconnect if I want to. But in the first instance it hovered until it hit low battery...

I sent an email with the same info as this post to Autel. So, we'll see. The last time I contacted them by email I never got a response. But that was at the height of the pandemic.

EVO II, shooting in AEB. Lately I've been getting some very strange results. Some but not all shots. Look at the attached EXIF data. I've gotten results showing exposures ranging from -7 to +8. And all the shots look way over saturated. The only camera settings I tinker with are the image size...

The thing is I have all kinds of devices that use SDHC and micro SDHC cards and the only time I get the error is when its a card out of the EVO II.