Recent content by deakbannok

I have a bad new. I was filming a sunrise from the foothills. My autel have ran out of battery at 30m. Broke my gimbal. I tried to manually bring the drone down. But it was not fastest enough from 800m with a 45% battery.

This mod will cost you $300-400. But you can also DIY this dual amplification for under a 100$. :)

It shall be fixable with a firmware? I have tried to shoot a video following behind a car uphill 10%. between 50-60 kph. It was able to keep up the shot. Because the drone tried to run aground and I had my stick push all the way up to try to keep leveling above the car. I have not tried to...

I am working in Paris. Most of the money spends to the social medical, education and others. But sometime I feel that is like a half of budget. I have seen alot of the luxery things that they have been decorated to the goverment officials. So If you have serving or working for the gov. You will...

Well it will cost $$$ to a small company.. EU will apply Taxes to them.

The spring I use is this one. But you have to trim it to 1mm. Just enough to compress the props to the locking position. US $2.31 11% OFF|10pcs compression springs 304 stainless steel tension spring electrical springs non corrosive extension springs-in Springs from Home Improvement on...

The props work great! I switched the props to the new version of mavic 2. They ars slightly wider and a few mm longer and they more aerodynamic desin with a blended winglet.They run slightly more quiet respond well with the inputs. But I still carry my autel props for emergency spare.

Installed a new antenna.

I have added a tablet bracket to the controller. You need to use adhesive tape or glue the mounting bracket and adjust it to your tablet. Best use on your tablet case.

I use PETG. They are best to print parts with. PETG is durable and flex, low shrinkage (best for accuration parts) food and bio friendly. Best for restance impact. PETG and slightly lighter weight than ABS. So in my theory it slightly lighter weight than the Stock propeller guards. Because there...

@mjbok Well it depends on what is the size of the tablet are you plan to mount it on the controller? On the mounting extender of the controller is about (55mm) with an extendable of (28mm). I don't have a tablet so I am not sure what are the average size of the tablet that people are using on...

For the community and those who have a 3D printer at home or at the office. Here I have been working on a few 3D projects for this drone. Let me know if you have any idea or thing to add. - Autel Evo Antenna Mounting Adapter 1.13 Pigtail Autel Evo Antenna Mounting Adapter 1.13 Pigtail. by...

@Spappy @jmbsmt63 After observing the flight record. I found that my left hand pitch is barely responded to input. What I did was do a calibration test on the controller. The pitch elevation is now much more responsive to the input. I did a test out on the coast with a 20mph+ wind. The drone...

In the video you can see I have stop pitching forward to try to gain elevation. It still going up very slow. Oh btw. Return home speed is 22mph now with a max of elevation of 650+ft

I have performed a test flight today out in the coast with various altitudes terrain on FW 1.3.3.25 Beta (All Stock). I was having a difficult time to get the drone to climb and descend the elevation. I hope the Autel will look into this. And dynamic track is not changing on elevation changes...